VERYLUBE LITHIUM GREASE for CV-JOINTS 125 ml

Consistent grease with molybdenum disulfide for hinges of equal angular velocity (SHRUS).Traditionally used in hinges of equal angular velocities of front and four-wheel drive vehicles. It withstands a point contact load of 3500 N.- Special lubricant for SHRUS- Reliably protects nodes and bearings working with peak and / or alternating loads-It has high mechanical and chemical stability, retains protective and anti-wear properties even after the action -long-term mechanical and thermal overloads- Thanks to the fact that it is good to stick, it remains on the lubricated surfaces even under the action of vibration and high speeds of rotation-Discontinuous and can be used in knots working in contact with water-Seals good insulation, and prevents contamination of the bearing-Color, visually: blackClass of consistency by NLGI: 2-Penetration at 25 ° C, x10-1 mm: 285-Drop drop temperature, ° C: above 180-The operating temperature: long, ° C: not higher than 130-The operating temperature: short-term, ° C: not higher than 150-The material is compatible with all types of automotive and industrial oils on a lithium basis, mixed with them in any ratioFulfills the requirements of the specifications:-NLGI 2 (ASTM D217)-ISO-L-XCCEB 2 (ISO 6743-9)-KPF2N-25 (DIN 51502)applicationIt can be used as a substitute for multipurpose oils based on lithium in nodes and bearings of automobiles, industrial equipment. Contains pure, highly dispersed molybdenum disulfide, which protects the nodes and bearings that work under peak and / or alternating loads.When using a fuel syringe for plastic lubrication. Bring the grease to the assembly through the press nut until excess of the blades of the lubricating compound is present.To fix lubrication in a hinge of equal angular velocities (SHRUS), it is necessary to disassemble the protective cover, remove the old lubricant, dismantle the SHRUS, disassemble it, pre-designating the location of all parts. Rinse the parts, assemble the SHRUS, keeping the previous position of the parts guided by the labels. Completely fill the inner cavity with the grease, place a protective casing and place the cog in place.With a manual bookmark. Fill with 1/2 lb of the free volume of the bearing (unit), removing the old grease before it.Notes:Compatible with all types of automotive and industrial oils on a lithium basis, mixes with them in any ratio.-It applies for nodes with a rotational speed of up to 10,000 rpm.